• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Vibration under accelaration

Theeulogy

Basic User
City
Washington
State
wv
I have a 84 Scrambler with a good amount of lift, 35 inch tires. I have a pretty stout vibration under accelaration. Not sure were to start looking.
 
Did you put in the lift? Likely that there's no camber shims with the stock setup and the driveshaft angle is too high. Look at the spring packs in the rear for some short angled blocks between the axle's spring pads and the spring.

Should look like this (only pic I could find quickly)

shim2-1.jpg
 
I'd start with the tires, rotate them front to rear and see if the vibration changes. If it doesn't change, go to the driveshafts. Check the U-joints, phase of the shafts and condition of the splines. Has the vibration been there all along or did you change something? Do you feel it in the steering or more in seat of your pants?
 
It came on fairly suddenly on a long drive, 30 miles on a country road. I just had a guy replace both my diffs and all the u-joints. I did however notice a bit of play in the one of the u-joints at the transfer case side of the axle. There was no vibration for a few weeks after the job, seems odd that one (new) of these could go bad so quickly. I will look into it in the morning after I get the the full hard top back on it.
 
Check you driveline angle first. Most exceraltion vibes are do to the pinion angle. The check you U-bolts and make sure your axle is not shift some on you. Tighten those suckers up. Then you U-joints. Take them out if it has been awhile replace them. They are cheap and easy to do. If they are new, inspect them well. Make sure they are lubbed up well, don;t loose any needle bearings :D
 
Just another thought:


I had bad vibration in the 35-55 mph range, (bad like the entire roll cage shook about 1" either way), after many suggestions, and trials, and $200 in new parts later, parked in the drive one night to look back at a 30 degree angle in the pass front tire, turns out the bolts that hold the backing plate to the hub of the axle, had all stripped, out of I think 5-bolts only 2-still had the nuts on them, I just got lucky that it gave out turning sharp in the drive and not at 75mph, like I had just ran coming home:eek:.

Again this is just another thought, because we looked at everything, and these bolts are pretty "hidden" and was overlooked by 4-people, 2- being professional shops, because everyone was concentrating on the suspension, driveshaft angles and such, so this was easily overlooked.
 
It came on fairly suddenly on a long drive, . . . I did however notice a bit of play in the one of the u-joints at the transfer case side of the axle. There was no vibration for a few weeks after the job, seems odd that one (new) of these could go bad so quickly.


From the description, I would bet it is a u-joint. If a u-joint isn't put in properly, having a cap fall off picking up a piece of sand or without releasing the yoke tension, you could wear a u-joint out in a thousand miles easy.

Drop the driveshaft and check the u-joints that way. A marginally bad u-joint can be hidden if attached to the drive line.
 
Replace the trans mount. Probably broken. allows torque vibes during acceleration. Check engine mounts as well.
 
Back
Top