What did you do with your Scrambler today? October 2014 version

[jak inc]

Marina 8

We yanked the pontoon boat with the Scrambler today. I had to use 4wd low at the launch. The picture was taken as we are getting ready to roof it in for the winter.

 

[dmock]

"I had to use 4wd low at the launch"

Good excuse to exercise the drivetrain!

 

[BRKLYNZ28]

What's wrong with this picture?


Sent from my iPhone

Nothings wrong 👍

Sent from my SPH-L900

 

[gazzo]

No rust in THAT spot or as I like to call it SPOT 3


Sent from my iPhone

 

[Randyzzz]

Well, I accomplished this over the weekend but am finally posting it here. Used Copper to tow Red out of the Costo carport and over by the garage. The VW bus now resides in the carport. This means that I can sneak a bit of work in here and there on Red. And, EBay was really productive this time around, so it's time to start amassing parts, and putting the finishing touches on Copper too!

Don't worry, Red is under a car cover when the weather gets nasty- like today!

 

[84scramblertex]

I am jealous. All I have done with the scram this month is move it out front to move the Chevelle and El Camino out of the garage only so I could get the Halloween decorations out of the attic. Too much work travel these last 2 months... I think I am going to have to take vacation just to spend time in the garage. I will say that she fired right up with no issues!

 

[Speedpin]

Just finished up the rear dana 44 pinion seal and removed small 8" leaf from front packs and added a 20" add a leaf. Firmed the soft +2 black diamond yj springs up nicely and gave me about 3/4 inch raise up front to set me level.

 

[BRKLYNZ28]

Well after 1.5 years I finally changed the heater blower motor . did a bigger motor upgrade also. Now it like a leaf blower on steroids.

Sent from my SPH-L900

 

[jak inc]

Well after 1.5 years I finally changed the heater blower motor . did a bigger motor upgrade also. Now it like a leaf blower on steroids.

Sent from my SPH-L900

That's one of the best improvements I have made to mine. You will enjoy it!

 

[Spieg]

Well after 1.5 years I finally changed the heater blower motor . did a bigger motor upgrade also. Now it like a leaf blower on steroids.

Sent from my SPH-L900

I'd recommend wearing safety glasses the first time you turn it on high... any leaves or cob-webs will come flying out of vents at high velocity.

 

[KINETIC]

Steering all finished up today. Can finally turn the tires using the steering wheel after almost 4 years.

 

[jeepmonkster]

What motor is that

I'd recommend wearing safety glasses the first time you turn it on high... any leaves or cob-webs will come flying out of vents at high velocity.

Could you share the motor make model and where you can buy them.
Thanks

 

[SHLTR2]

Steering all finished up today. Can finally turn the tires using the steering wheel after almost 4 years.

Is that two identical pressure hoses I see on that pump? That looks like a nice clean way to run them...

 

[Spieg]

Could you share the motor make model and where you can buy them.
Thanks

This is what I used from

NAPA

 

[KINETIC]

SHLTR2

Yes they are, had a local hydraulic shop bend them up for me. Nothing stock would clear the radiator.

 

[Spieg]

Discovered I need new ball joints;
[video]http://vid1280.photobucket.com/albums/a486/Spieg8/My%20Movie_zpsd4fxdbtf.mp4[/video]

Happen to have these on the shelf. Going to be a fun repair (NOT!).

 

[gazzo]

Front yolk seal and new t case oil.


Sent from my iPhone

 

[gr8dain]

Failed state inspection. It has rot in the frame over the rear axel. Oh and a leaky brake line. Grrrr.

 

[KINETIC]

Finished up installing the MAF and K&N filter today.

 

[hastings215]

Washed her for the first time in a long time.
Now she's lookin all perty.