- City
- Molalla
- State
- Or
Today I just removed the roll bar from an 81 that hadn't been disturbed since new. Only two of the sixteen came out without heat. Heating up the head of the bolt breaks the rust bond on most of them. Heating the nut expands it and usually gets the tougher ones. Those two that the socket and ratchet won't fit on were the worst. I used the torx socket with a small boxed end wrench on the torx part and a large cresent wrench on the small boxed end wrench. I heated the head of the bolt and let it cool. Heated the nut and let it cool. Used PB blaster from the bottom and they screeched out a small part of a trurn at a time. PITA but if you are determined you should be able to do it with using a cutting torch. I bought a couple T-25 bits today to try to make a short tool for removing them next time. I send them out for zinc plating and then grease them when they go back in. And of course run a tap through the nuts. I don't doubt that some of you have some bolts rusted worse than mine. I always take the bulkhead out first, too.
Oxy/Acet torch is a requirement to take an old Jeep apart.
Oxy/Acet torch is a requirement to take an old Jeep apart.

