• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

WTF-Roll bar removal

Today I just removed the roll bar from an 81 that hadn't been disturbed since new. Only two of the sixteen came out without heat. Heating up the head of the bolt breaks the rust bond on most of them. Heating the nut expands it and usually gets the tougher ones. Those two that the socket and ratchet won't fit on were the worst. I used the torx socket with a small boxed end wrench on the torx part and a large cresent wrench on the small boxed end wrench. I heated the head of the bolt and let it cool. Heated the nut and let it cool. Used PB blaster from the bottom and they screeched out a small part of a trurn at a time. PITA but if you are determined you should be able to do it with using a cutting torch. I bought a couple T-25 bits today to try to make a short tool for removing them next time. I send them out for zinc plating and then grease them when they go back in. And of course run a tap through the nuts. I don't doubt that some of you have some bolts rusted worse than mine. I always take the bulkhead out first, too.
Oxy/Acet torch is a requirement to take an old Jeep apart.
 
I won.
y7a2e3e6-1.jpg


Cut and beat on with a chisel and hammer. But, the roll bar is out.
 
If that's one of the hardest then I feel better. The other good thing is there was minimal surface rust under the roll bar. Some wire wheel work and paint to protect it and then remount the roll bar.
 
If that's one of the hardest then I feel better. The other good thing is there was minimal surface rust under the roll bar. Some wire wheel work and paint to protect it and then remount the roll bar.
Congratulations.
Since that one is damaged, I have some OEM ones from mine I'd be willing to part with for your remount. :rolleyes:
 
Thanks a bunch Jim.

FLCJ8, I already have access to some spare bolts but thanks for the offer.
 
I double checked mine today. PO already swapped mine out for hex bolts. That goodness.


Dain
 
You are luck if you don't have to mess with them damn torx bolts.
 
Back
Top