jsteed
CJ-8 Member
- City
- Tucson
- State
- AZ
Been a while since I've been on here. Was just working on the 8 this weekend, and really giving it a good going over. Actually considered selling it. There's so much to do to it - she's a real basket case. Some of you may have read one or two of my other threads, but what this thing really needs is a complete tear down. My only problem is that I don't have the shop space to do that, so I can't pull the tub. Or maybe I could but either the frame or the tub would be outside. In Seattle. Ugh. It would be nice to pull it so I can redo the transmission seals, transfer case, rear main, throw out bearing (obviously wasn't done when the clutch was replaced before I bought it! ugh!), leaky freeze plugs, fuel lines and vent hoses, gas tank, blah blah blah. Then replace with new steel tub. Here's the problem - the jeep runs, and drives and stops and takes the kids on FS road rides near our cabin in the summer. So I thought well maybe I'll sell it and buy a nicer one. Then I started shopping... dang these things have gone up in value. No way I can afford to drop close to 20k on a "needs nothing" Scrambler. So here I sit. Maybe I'll just keep driving it as is until a leak gets too bad to ignore, or a part fails and just replace things on an "as-needed" basis. The tub rot is really bad in the rear floor pans (front were replaced at some point), rear riser, bed, rear quarter panels, and below doors. When I pulled up the fiberglass that someone laid over the rust I was appalled at what I saw. Really, I'm just wondering what to do to it or with it. I just can't see myself not owning one. Anyone else been in this spot? Curious how you approached it, what things you prioritized, etc. I also feel like I don't have anyone to bounce ideas off of in Seattle. Any local Seattle members on here if I ever needed someone to look at it? Or maybe a recommendation for a local shop for the things I can't do in my small 1 car garage?
Thanks, I hope everyone is safe and healthy.
Thanks, I hope everyone is safe and healthy.

And if I'm going to be welding back there, I should probably pull the gas tank, inspect, clean, and replace what I know is a leaky vent line (smells like gas when tank is full).

