sevensandeights
sevensandeights
- City
- Mckean
- State
- PA
I am using the skid plate from my 1981 Scrambler on my near mint 1983 Scrambler frame. I am ready put the engine/tranny/t-case in. I am having a hard time lining up the skid plate bolts. All my measurements indicate i am using the correct holes in the frame and skid plate. The two outside sets of holes (forward most and rearward most) on the skid plate are slotted but the middle holes are not.
I am having trouble with the middle holes. I need about a 1/2" - I think I have seen pictures of a bottle jack used to spread the frame rails a little. Has anyone ever had to do this?
I am having trouble with the middle holes. I need about a 1/2" - I think I have seen pictures of a bottle jack used to spread the frame rails a little. Has anyone ever had to do this?


