• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Anyone ever used a bottle jack to spread the frame rails for the skid plate bolts?

sevensandeights

sevensandeights
City
Mckean
State
PA
I am using the skid plate from my 1981 Scrambler on my near mint 1983 Scrambler frame. I am ready put the engine/tranny/t-case in. I am having a hard time lining up the skid plate bolts. All my measurements indicate i am using the correct holes in the frame and skid plate. The two outside sets of holes (forward most and rearward most) on the skid plate are slotted but the middle holes are not.

I am having trouble with the middle holes. I need about a 1/2" - I think I have seen pictures of a bottle jack used to spread the frame rails a little. Has anyone ever had to do this?
 
I had to do it on mine. but a bottle jack will not work on its side. I used a screw type jack.
 
Good point! You think I could do it with a Hi-Lift jack? There wouldn't be much fine adjustment though!

I could flip the rolling chasis on it's side if I really had to so I could use the bottle jack in the upright postion but I certainly would rather not do that.
 
Lol... I hear the soundtrack from the movie "deliverance" playing in my head.
 
I had to use a bottle jack on my red Scrambler when I first put it back together. The bottle jack worked, but not so well, on its side, a screw jack would be better:thumbsup:

If you use a jack, make sure to use some blocking to spread the load, or you could dent the frame, ask me how I know:rotfl:

When I recently swapped transmissions in the red Scrambler, upon reassembly I was able to use a small pry bar to line up the holes, the frame had only shrunk by maybe 3/8":wave:
 
A bottle jack will work if the valve is placed at the bottom. X2 on the wood block to spread the load.
 
Using advice from another forum I ended up squeezing my skid plate in a Hi-Lift jack to narrow it rather than trying to widen the frame. It took 5 minutes and worked perfectly!
 
I believe that the frame narrowing in the skid area is the culprit to blame for the shackle spread up front...
 
I had to use a pry bar on "Yard Scrambler" this weekend to install the skid plate, the frame shrunk in about 3/8", just like my red Scrambler:thumbsup::wave:
 
Back
Top