jeepnjeff1002
Basic User
- City
- Louisville
- State
- KY
I haven't forgotten about this thread, just waiting on several things:
Totally stainless to deliver all my hardware so I can start assembling some things.
Getting my frame back. I had a local jeeper repair some rough spots and re-enforce the rear spring hangers. When I get the frame back I will mount the axles so I can finish off the remaining tasks of upgrading the yokes, replacing the rear pinion seal, and installing the front lockouts. I also had to order a spring plate/u-bolt kit for the dana 60 since the old front axle was a dana 44.
Here are a few pics of my newest parts:
Edelbrock performer intake:
Stock intake heat shield cleaned up:
And installed on the new intake:
M.O.R.E. bomb proof motor mounts:
Expensive but hopefully worth it.
Totally stainless to deliver all my hardware so I can start assembling some things.

Getting my frame back. I had a local jeeper repair some rough spots and re-enforce the rear spring hangers. When I get the frame back I will mount the axles so I can finish off the remaining tasks of upgrading the yokes, replacing the rear pinion seal, and installing the front lockouts. I also had to order a spring plate/u-bolt kit for the dana 60 since the old front axle was a dana 44.
Here are a few pics of my newest parts:
Edelbrock performer intake:
Stock intake heat shield cleaned up:
And installed on the new intake:
M.O.R.E. bomb proof motor mounts:
Expensive but hopefully worth it.





