Scramblerdiesel
Basic User
- City
- Divide
- State
- Co

BTW, this swap favors the stock 4 speed tranny. I have spoken to guys who have swapped in the AX 15, and the Merc just doesn't like it. It smokes and bogs down, asking you to rev higher. Another reason that this is a cheap swap. Just bolt it to the CJ tranny, and go have fun.
What tires and axle gearing do you have? I am real close to pulling the trigger on a diesel swap with either modified SD33T (have), military 6.2 (have and is low mileage) or MB (don't have but have source from MB mechanic friend). Do not wheel my Scrambler (have a trail rig) and it is not my daily driver. Have too many rigs/toys can't justify the cost of 4BT and don't need the power.
I have owned several MB diesels over the years and love the engine. I also like the simplicity of mechanical injection and hour comment about non OD transmission. I would use TF999 (have several) in either lockup or non lockup.
I have 33" tires with 3.73 axles. Climbed the Ute Pass today (6000 ft to 9500 ft and it held 55 with no problem. Lots of turbo noise ;-)
Yes, not needing to worry about the overdrive is one of the main the arguments for the OM617. HUGE powerband.
Sweet! I have 4.10 gears with 35" BFG ATs and my concern with both the SD33T and 6.2 is they both have fairly narrow power bands. I have a WC T5 behind my tired old 4.2 and it struggles to hold 70 on the Interstate with a head wind and flat ground. Promised the wife would make it an auto when I replaced the engine.
Did you do a writeup on your MB engine swap? Would love to hear and see pictures of how you did motor mounts, power steering, etc.
I noticed that they have an adapter to fit the T5, which I have, but the strength would scare me a bit with the higher torque rating of the diesel motor.
Hey Greg, you make the swap sound like it is really simple. I've reviewed that site in the past, and it seems like motor mounts and an adapter plate is all there is to it. Isn't there any concern about the old fuel lines and tank, exhaust piping, radiator, etc.? How much of the MB guts does a person need, to properly perform this diesel swap?
Also, how much spring lift was required for you to clear the front axle?
I don't think the MB diesel has very much torque. This was the reason I never paid a lot of attention to this motor until this post, that is, since it indicates that a user experiences good success at our steep inclines in CO. Torque is king, but I think the OM617 has less than 200lbs., which isn't much different than the 258-I6. I could be way off on this, but that is what I remember reading once.



