• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

rebuilding a D 300

don87401

Original Owner
BENEFACTOR
Gold Member
Silver Member
Lifetime Member
SOA Member
City
Farmington
State
NM
What is the best kit for going through a D 300 no gear issue just starting to leak every where.
 
Novak master rebuild kit # 300mr-2 for long output or # 300mr-1 for short output . I have not used the paper gaskets just gasket silicone . Put it on all threads as well.
 
Thanks I was leaning towards Novak. Now I have to figure out short or long and if I changed the out put or not been a looonnnggg time ago when I did any changes. I didn't keep a book on the Scrambler like I am doing on the CJ 6.
 
I think the long is something like 6.5" from mounting surface on the case to half way through the u-joint.
 
my D300 leaks as well- especially in 4wd. How hard are these kits to install? I haven’t done any gear or transmission work, but am interested to learn.
 
Not hard at all. You just need a press , clearance gauges and an indicator . There are some tricks to getting around having a press but all have potential to damage IMO. The rest are just normal tools. The Dana300 is actually pretty simple . There are some pretty good videos out there and the NOVAK instructions aren't bad either. Pay close attention to end play and clearance.
 
Easy to tell wich output you have. The long output has an eccentric speedometer gear that clocks to adjust for gear size. The short output does not.
 
Long output case is around 5 1/2" and short output case is around 3 1/2"
 
I have the press, feeler gauges, mics, and an indicator. So I think I have the tools and knowledge to follow instructions. And a tablet to take to the shop for the videos.
 
Sounds like you are set up . Shouldn't be any problem. 4-6 hours if you clean all parts after breaking down.
 
Back
Top