Hopefully this helps. Fist I’ll post pics of the passenger side.
The release handle is on the right side of the seat, towards the door panel. Both the flanges that bolt to the floor angle inwards, towards the center of the tub.
Pic from the pass door-
View attachment 104675
Pic of the inner mounting flange-
View attachment 104676
Now over to the drivers side. The release handle is on the left side, facing the door panel. The flanges that are moulded both face outward- the outside flange faces the drivers door, and the inside flange faces the drivers door. These appear to be the passenger flanges, just mounted opposite from the pass side.
View attachment 104677
But if you look close, you will see that there are no bolts in the inside flange! That’s because the bolts go through two tabs that are welded to the bracket. These tabs face the center of the tub.
View attachment 104678
These brackets came out of a 1985 CJ7 and were factory original. I assume you could add these tabs if your bracket doesn’t have them.
It almost seems like the driver’s slider was an afterthought from the factory, or possibly by welding the tabs they could use the same lower brackets as the passenger side. The drivers folding bracket mechanism is a couple inches lower than the passenger side, to accommodate the height of the slider.
I sprayed mine with bedliner, and the drivers latch rods were a hair loose, so I used .50AE cases to shim them to size.
I also welded cross braces from side to side to stiffen the whole mechanism. I think the reason we see so many cracked seat frames is because of the flex in the bases. Here’s a couple pics of the drivers side. I also mounted the sliders back a couple inches to get full rearward travel.
View attachment 104679View attachment 104680