Update on Speedhut Guages
Wow! Hard to believe its been more than 3 years since since I started this.
This has to be one of the easiest reviews to write ever. I absolutely love the Speedhut gauges. I haven't had any issues in 3 years.
The clock works great; and is easy to set. Only downside on this item, and I knew it going in, was that the clock doesn't get the same LED driven illumination as the rest of the gauges.
Tachometer works really well. Very responsive; no issues.
Oil pressure gauge has been great. I am sure the new OEM quality two wire sensor is more accurate and longer lasting than the AMC Jeep one wire sensor.
Not much to say about the voltage gauge. Works great. Easy to tell if the alternator is charging (at 14V+) or not (12.3V).
Speedometer is easy to read and works great. Once in a blue moon if the Jeep hasn't been out of the garage for a month or so; the gps will forget its location and will take a block or so to find it and then start working (I didn't put provisions in for the backup going into the TC). Getting rid of the cable going to the TC was one of the best reasons to go to the Speedhut setup; one less mechanical, trouble prone, mechanical cable.
Fuel gauge works great at this point. It did take me a couple of months to get the "range" setting in the Speedhut setup correctly. I have 98% confidence of not running out of fuel with this gauge. Why 98%? Because I didn't replace the AMC float style sender (that may eventually fill with fuel). I am kinda kicking myself for this detail. I have already decided when I retrofit to fuel injection that the tank will get a more modern sender, either the Speedhut capacitance one (requires one more wire to the fuel tank) or I may do the GM LS in tank pump assembly.
Temp gauge works well. Accurate enough that I can tell almost exactly when the thermostat is going to open and level out. I wish it had actual temperature numbers (I know it would be less historically correct; I'd be fine if they made it read from the multifuction display in the middle) for tuning my fan controller. I also wish this had come with a 2 wire OEM type sensor.
The Painless / Speedhut swap had to be the biggest improvement in reliability of any of the changes or fixes I have made. Before I did the swap, it would reliably leave me troubleshooting with a multimeter or test light on the side of the road every couple months. Now it has been a couple years since that happened; and it was with wiring that wasn't part of the swap (the wire going from the ignitiion relay fell off the terminal to the HEI).
Great project!! Highly recommended!!