I highly doubt it, it was peined onto the shaft and I have only driven a few thousand miles.Has the 5th gear nut backed off? That is usually a problem with high vibration diesel trucks, not gas engines though.

I highly doubt it, it was peined onto the shaft and I have only driven a few thousand miles.Has the 5th gear nut backed off? That is usually a problem with high vibration diesel trucks, not gas engines though.
I have removed the shift tower and even tried a new one from advanced adapters. Same issues.I would suggest removing the shift tower and looking inside the transmission. Or at the least the PTO plates on each side. Something does not sound right inside it.
That does help, what is the part number of the oil you are running? I talked to my local Chevrolet dealer and they said it is discontinued.I run the OEM GM NV4500 oil. I've heard NV4500s are super picky with oil.
below are my clutch parts that I run. I put the cheap crap in because I wasnt sure what would work and I didnt want to waste money on the expensive stuff. 11-12 years later its all still working great.
Throwout Bearing - 1962 Chevy Belair 3.8L inline 6 - National P/N 1697C
Flywheel - SACHs p/n NFW1050
Clutch kit p/n 04-232
pilote bearing - GM p/n 12557583
dunno if any of that helps but..
I will crawl under there and take a look. Not sure if I will be able to see through the bell housingdunno if some said it already but check and make sure your throw out bearing isn't in contact with the fingers of the clutch when the pedal is fully disengaged.
I went through a ton of different throw out bearings before finding the one that didn't touch.
Come to think of it, I've heard that the counterweights on the center force clutches can cause problems too, but i've never has experience with them. Another reason why I went cheap on the clutch... rockauto special
From engine to transmission length I mean.I am wondering what the width of your bellhousing is. I am running a bellhousing off of a 454 Chevy. Curious if maybe it is too short?
This is what I have. An NV-4500 that was behind an LS 6.0. 2003 I believe.Im pretty sure Im running a factory bellhousing for when the GM trucks actually had an LS and NV4500 from the factory. I think they were made for 3 or 4 days, there wasnt many.