• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Vortec V-6 Engine Placement

psiklist

Basic User
City
Tucson
State
AZ
Wondering if anyone can help me out with determining optimal engine placement location. Several years ago I purchased an 81 Scrambler that was in dire need of restoration. This was an Arizona vehicle with no rust but the little 151 was shot. I elected to do a frame up restoration with the installation of a 2004 Chevy Vortec V-6 coupled to a 4L60e. However, I am stuck in 'paralysis of analysis' mode in determining the proper engine location. The good folks at Novak have been helpful to a point but I'm not comfortable with the information that I have. Does anyone have any measurements that could be used as a guide?
 
Welcome! Are you using the stock front axle? Any lift? I can't provide any exact measurements, but your biggest hurdle is front driveshaft clearance past the trans pan. Using the stock front axle, I'd think you would want to offset it at least 1"-2" to the drivers side- making sure to allow room for the steering shaft. You have latitude in front to back placement- again, front driveshaft angles will influence that. There's plenty of room if you mount the engine all the way back, I'll attach a pic of my 5.3 install. I went with a driver's drop front axle to easily clear the trans pan with the driveshaft.

intermediate shaft 002.JPG
 
I've heard that the engine mounts from MORE place the engine correctly and are bolt-in. I used them for my AMC 360, but they're pretty well set already, since it's close to a stock install.
 
John,
Thanks for the reply. Wish I had know about the M.O.R.E. engine mounts last year. I already bought mounts from Novak and I doubt that they can be returned at this late date. I still may bite the bullet and buy these.
 
Thanks Randy. Are theses M.O.R.E. mounts? If so, then I think that I'll need to go that route.
 
I've heard that the engine mounts from MORE place the engine correctly and are bolt-in. I used them for my AMC 360, but they're pretty well set already, since it's close to a stock install.

what john said...and they will work if you ever want to drop in a 5.7 also
 
Just did this on an 83 CJ... 99 vortec 350 and 4l60e. Used the advanced adapters mounts. It places the motor about 1" to 1.25 " to the left. Found that for more front driveshaft clearance given this 83 being more of a stockish height it should be more like 1.75 to 2 inches. I think the MORE mounts accomplish this. There is alot of info on this online google 4L60e in a CJ. It's a big pan to clear.
 
ImageUploadedByTapatalk1364218575.124839.jpg

This was a few weeks ago during the fitting of everything stage. Used a broom handle to mock things up then elongated a factory front shaft. It is a tight space to fit it in there you can see how close then Dana 300 yoke is to the pan, too.
 
Thanks Randy. Are theses M.O.R.E. mounts? If so, then I think that I'll need to go that route.

Yes, those are the MORE mounts, and while I love the adjustability of Novak mounts, I think the MORE mounts are the best in the business. I made my own adapter plates because these were originally for a SBC 350, but I think MORE makes Gen3/4 bolt in mounts now. They are stronger than strong, and pretty much center the engine. If you want more pics I can dug some up later...I think most of my build thread pics went away and i haven't fixed it yet....
 
Back
Top