firefighter736
Basic User
- City
- Floyd
- State
- VA
mhinchliffe reminded me that I hadn't updated my thread in a while.
I practiced removing spot welds on the corner that I am replacing. I learned that drilling a pilot helps quite a bit.

I've almost got all of the holes (from the top snaps) in the side filled. Not perfect, but a tiny bit of filler or high build primer should take care of it.

I didn't have a 20amp breaker for my welder setup at the shop yet so I had my buddy weld up a couple of engine stands to make a rotisserie.

I practiced removing spot welds on the corner that I am replacing. I learned that drilling a pilot helps quite a bit.

I've almost got all of the holes (from the top snaps) in the side filled. Not perfect, but a tiny bit of filler or high build primer should take care of it.

I didn't have a 20amp breaker for my welder setup at the shop yet so I had my buddy weld up a couple of engine stands to make a rotisserie.









Called 4WD and as soon as it gets back to their warehouse it will be shipped back to me.
