• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Search results

  1. C

    5.3 vortec swap

    I am with Randy on this one. Buy as much of the donor as possible all at once.
  2. C

    Anyone running GM 6.0/4L80E ?

    I havent put a 4l80 in a jeep, but I have worked with them in other stuff. I put one behind a fire breathing 6.0 in a 63 vette.... Here is what the two look like side by side on the floor: The 4l80 is longer, wider and heavier. The housing is slightly "flat-er" on top just behind the...
  3. C

    How much will it cost?

    You will need new carriers for both the 20 and the 30. Ratio break on them is 3.08 and 3.54 respectively. In my opinion, 4.56 gears will give you a nice all around drivable rig. More serious offroad intent, you will want 4.88. 4.10 would still mean 5th gear on highway only with no big hills...
  4. C

    Which way does the Catalytic Converter get installed?

    Like mysunn said.... the small side tube points forward. It is supposed to hook to air pump system to inject fresh air into cat when some other vacuum powered temp switch told it to. One of the worst pollution control ideas ever.
  5. C

    carb for my 360

    Qjet will run well if it is clean, the float level is adjusted properly and the float itself is not saturated with gas. I have seen them run all kinds of stupid steep angles with no problem. Next best thing to EFI. Another that works equally well offroad is the Autolite 4100. Very similar...
  6. C

    AW4 ODB1 swap.

    Call Hesco again, they can help. I am pretty sure they offer a "modifed harness" for the AW4 setup. I think the changes are essentially to tie in to TPS and either tach or crank position sensor I believe. This tells the little transmission module (which has harness of its own) how fast you...
  7. C

    Why.?.

    I have seen this done before on vehicles that were going to be driven in deep water. It is one of those things where if you are rebuilding and think you may want to swamp run at some point, you go ahead and do it so you dont have to take it apart and do it later. it doesnt hurt function for...
  8. C

    ze german intake heater?

    Definite factory gizmo. The VW version is probably a replacement part that was put in using handy-dandy cross reference numbers. It is supposed to heat the air/fuel charge as it enters the manifold at low temperature to 1. prevent/reduce condensation inside the manifold while cold and 2. aid in...
  9. C

    4.0L to 4.2L head swap

    Those sites look good and have a great parts list. As an alternative to the epoxy/JB weld solution for the water jackets, call a local shop and see if they can weld them up for you. Unless you have a super low mileage head you may want to get it dipped/cleaned and grind the valve seats anyway...
  10. C

    POS vapor lock?

    A dent in the skidplate wont matter. That would only be an issue, maybe, if the skidplate and tank are touching at the dent and vibrate together which may make a hole eventually. But, taking a hit hard enough to make a dent could affect your pick-up tube, vent lline, etc... I would check...
  11. C

    POS vapor lock?

    So, am I understanding right.... that it runs fine when the tank is full (other than the ping)? And trouble starts at less than 1/2 tank on hills? Have you looked inside the tank? Your intake tube, screen and pick up may need some attention. If it cracked part way up or some other wierd thing...
  12. C

    new weber and backfire

    I think CBRogers is right on. Sounds like you need to work on your vac system. Leaks or a ported pressure/manifold pressure connection in the wrong place can cause all the symptoms you are fighting.
  13. C

    Rain and motor issue

    Wayne - Sounds like you coverd the engine with your water hose testing. Did you do as Sunnshine suggested? Try checking on the fenders and firewall areas. Your ignition box, starter solenoid, or one of your system grounds could lose contact with moisture and would make an intermitent problem...
  14. C

    Cracked Waterjacket

    Not normal. But, only leaking oil when you turn left is odd too. Did you notice it by seeing smoke when you turn left? If so, probably leaking all the time and only runs into exh manifold and smokes when it puddles up and you turn left. You can: - fix valve cover gasket , put the bolt back in...
  15. C

    Thermal Limiter Valve?

    That is a thermal sensor for cold/warm air intake. D5DZ-9E862-A ~ MARKED: D5DF-9E862-AA OR D4ZZ-9E607-A > color coded YELLOW D0ZZ-9E607-B > color coded BLUE You can get one at ford. Or NAPA can cross to the Motorcraft number. Or you can go without it. It decides whether to pull in cold...
  16. C

    302 Engine swap...

    I think the 302 is a great swap. I pulled the 302 (5.0) out of an exploder with the 4r70w and with a clocking ring it bolts right up to the d300. Things I had to do that "wouldnt have had to happen anyhow": made new cross member, modify fuel system to high pressure with return line, new...
  17. C

    Dana 300 parking brake?

    Another way to go on this would be a hydraulic line lock. You could lock just the rears, or all four wheels. These were a requirement back when I used to do tractor/truck pulls.....
Back
Top