- City
- Rock Hill
- State
- SC
Hey guys, I am swapping my narrow axles for wide and have my old axle out. My old axle has an SSBC disk break setup that I wasn't going to use again, but while taking the axle out I realized why the parking brake isn't working so have changed my mind. So, taking the brackets off of my old axle I found something I haven't seen before and am hoping you all might be able to help me identify it.
I think this is an external bearing-sandwich-thingy.
So, there are no bearing in the end of the axle tube. Instead the bearing appears to be within this red anodized aluminum sandwich between the end of the axle housing and the backside of the face of the axle that the wheel mounts too. Like, the bearing is OUTSIDE of the axle housing!
Have you all seen this before? It's a Summers Brothers kit and while no one says their product isn't good, apparently their customer service is horrible. These axles were upgraded to one-piece by the PO some 20+ years ago, and I haven't yet found any photos of other axles like this.
Anyway, I've got to figure out how to get the crush sleeve off that is holding it in place so I can get the bracket off to put onto the new axles. I'm on the fence about using these "bearing sandwiches" if they will even fit the replacement axles axle shafts.
Hoping you might have some experience with one of these! Jeff
I think this is an external bearing-sandwich-thingy.
So, there are no bearing in the end of the axle tube. Instead the bearing appears to be within this red anodized aluminum sandwich between the end of the axle housing and the backside of the face of the axle that the wheel mounts too. Like, the bearing is OUTSIDE of the axle housing!
Have you all seen this before? It's a Summers Brothers kit and while no one says their product isn't good, apparently their customer service is horrible. These axles were upgraded to one-piece by the PO some 20+ years ago, and I haven't yet found any photos of other axles like this.
Anyway, I've got to figure out how to get the crush sleeve off that is holding it in place so I can get the bracket off to put onto the new axles. I'm on the fence about using these "bearing sandwiches" if they will even fit the replacement axles axle shafts.
Hoping you might have some experience with one of these! Jeff
