• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

First scrambler build!

So that's just straight 90w?

Not all "gear oil" is safe for the brass blocking rings inside the transmission. The container will say "yelllow metal safe", or something to that affect. Older/cheaper gear oils will degrade the blocking rings.
 
I use the Amsoil 75/90 Synthetic. Seems to work very well in all tempatures. :twocents: :wave:
 
df3b09dbb64bca0a446e6796a1389fa3-1.jpg

Could someone help to make sure I don't screw up this wiring. I think I've got the volt meter wired up correctly but not sure on the oil pressure. I believe the bottom is ground but don't know which one is signal or power


 
On that top gauge all I see hooked up is the light. On the volt meter the only thing that would happen if it was wrong is that it would read negative which in that case you just switch the two wires.
 
On that top gauge all I see hooked up is the light. On the volt meter the only thing that would happen if it was wrong is that it would read negative which in that case you just switch the two wires.

Yes, the oil pressure gauge (top gauge) is the one I'm having trouble with.


 
My wiring diagram show a red wire and a purple wire from the Jeep harness. I noticed that it looks like you are using a Painless harness. If so every wire is usually marked exactly were it goes.
 
My wiring diagram show a red wire and a purple wire from the Jeep harness. I noticed that it looks like you are using a Painless harness. If so every wire is usually marked exactly were it goes.

Yeah it's a painless kit and I've got a red and purple but don't know which one goes where. They are labeled "oil pressure" but doesn't show which wire goes where


 
Yeah it's a painless kit and I've got a red and purple but don't know which one goes where. They are labeled "oil pressure" but doesn't show which wire goes where

The purple/violet is from the sensor. (the sensor goes to ground and the resistance varies depending on the oil pressure sensed)

The red is from the ignition. (it should have 12 volts present when the ignition is on)

Therefore the purple would go on the left stud, and the red on the right.
(the studs may be labeled beside the studs under the ground/mounting strap)

gauges.JPGsensors.JPG
 
The purple/violet is from the sensor. (the sensor goes to ground and the resistance varies depending on the oil pressure sensed)

The red is from the ignition. (it should have 12 volts present when the ignition is on)

Therefore the purple would go on the left stud, and the red on the right.
(the studs may be labeled beside the studs under the ground/mounting strap)

View attachment 52639View attachment 52640

That's what I needed...thanks!


 
Alright so I'm bad about not taking many pictures and updating my post. I've got the engine back from the builder. I decided I'd go ahead and get the header and intake bolted up but I thought I'd seek a little advice from some of you that have done this. I've got the 1 piece headman header and factory intake. The intake is flanges are thicker than the header which makes the washers on the mounting bolts not sit flat. Anyone had this issue? Maybe I'm missing something here


 
Are exhaust manifolds thicker than the header? Manifolds flanges may be as thick as intake flanges
 
Are exhaust manifolds thicker than the header? Manifolds flanges may be as thick as intake flanges

I'm thinking the factory exhaust manifold was probably the same thickness as the intake. I'm not sure since my jeep had an older 2 piece header on it when I purchased it


 
Back
Top