- City
- Richmond
- State
- TX
So.... what should I do?


I have a puddle of resin on the fender under the vapor canister from the stock (original) ignition module. I’m certain it is still working as the engine runs (poorly due to carb issues, I think).
I can:
1. Leave it as-is and run it
2. Clean it up and repot it with electronics potting resin
3. Replace it with the module from my ‘82 that was a know good one
4. Replace it with an unknown module from an engine in the barn that was “thrown in” when I bought the replacement frame for the ‘82
5. Get a new one (not likely with all the reports of doa units)
I‘m up for suggestions


I have a puddle of resin on the fender under the vapor canister from the stock (original) ignition module. I’m certain it is still working as the engine runs (poorly due to carb issues, I think).
I can:
1. Leave it as-is and run it
2. Clean it up and repot it with electronics potting resin
3. Replace it with the module from my ‘82 that was a know good one
4. Replace it with an unknown module from an engine in the barn that was “thrown in” when I bought the replacement frame for the ‘82
5. Get a new one (not likely with all the reports of doa units)
I‘m up for suggestions
