
Silly question but when you did the wires did you make sure that it was at TDC. It sounds like maybe you have the wires 180 degrees out. IIRC, the SBC will run with wires in bad order but make no power. Just because crank was at 0deg does not mean that you were not 180 out. Need compression on #1 plug.
Carl

HEI is the way to go. But in the mean time you should check the points.
I don't have time to explain the whole check/ adjustment process as I am off to U of M to see my dad. They put him in a new left lung Saturday. But here is a pic I scribbled the basics on.
View attachment 56434
Another option for the distributor is change out the points for a Pertronix electronic unit. The nice part is that you will not have to change your plug wires too. So have you checked the fuel pressure yet?
The points cap and HEI cap require different spark plug wire terminals.
Fuel pressure/fuel flow. Have you changed the fuel filter on the side of the Q-jet yet?
Sent from my SM-G920V
If you want them, I have an old dwell meter and the tool to adjust the points when the car is running. I have no use for them currently. You can use them, if you want.