• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Where do you jack up your Jeep

Wayne

Legacy Registered User
City
Cape Coral
State
FL
Hello:
I tried looking through other posts to see if this was already addressed - im sure it has, but I cannot find any info on the subject.
I have a stock 8 with 33' and I want to take the two fronts of at the same time - where underneath do you jack her up to do both?
Also - what about doing one side - all I have is a small trolley jack.
As always, cheers.
 
I have a large truck jack and I put it under the pumpkin. Have an 1/2" piece of plywood that fits into the jack dish. Seems to keep things happy when lifting esp under pumpkins.
 
Do you have any jackstands? The proper way, even though not the most expedient, is to jack up each side and put jack stands beneath the axle as near to the knuckle as you can get without rubbing the tire. With the wheels off, it's a good time to check brakes, ball joints, u-joints, wheel bearings and dialouts, and it's much safer to do that routine while on jackstands.....assuming they aren't the problematic lot from HazardFreight.
 
Lift one side at a time and use jackstands under the axle to hold it up. Getting a good sized floor jack and larger jack stands (I actually recommend getting at least two pairs of a couple sizes) is going to pay off in the long term.

Do not work on a vehicle only held up by a jack.
 
Lift one side at a time and use jackstands under the axle to hold it up. Getting a good sized floor jack and larger jack stands (I actually recommend getting at least two pairs of a couple sizes) is going to pay off in the long term.

Do not work on a vehicle only held up by a jack.

Totally agree, i normally throw the removed wheel under the leaf spring somewhere as well as a backup just in case.
Also gets the thing out of the way to give you a bit more room to work.
 
Had an Austin Mini come off a pair of jacks once, scary, fortunately no-one was underneath and the tyres were on, so no harm except to my nerves. (No i in tyres note).

I was wondering about some of the bent stuff on my 8 when i received it, eventually figured out that a PO had it jacked up on the front pumpkin and it must have slipped off, bent the tie rod and the front driveshaft in the process. There was a telltale scraping of gunge off the pumpkin that was the hint.
 
Another vote for jackstands. I dated a lady in my early 20's, she was under her car with only a floor jack, and down it came. End of lady I dated in my early 20's.
 
My bad real poor advice. Jackstands are an important part of personal safety and vehicle preservation of which I omitted. To my defense I answered the how part I would lift my vehicle with no further follow up. If you lift a vehicle make sure that it is properly supported.
 
Last edited:
Totally agree, i normally throw the removed wheel under the leaf spring somewhere as well as a backup just in case.
Also gets the thing out of the way to give you a bit more room to work.
I've always done that same exact procedure (y):giggle:
 
FWIW, Hemmings ran a short article couple months ago that several Harbor Freight red and grey jack stands with specific id numbers (can’t remember numbers) were recalled due to defects/collapsing or something. I just googled it, it’s on the web.
 
FWIW, Hemmings ran a short article couple months ago that several Harbor Freight red and grey jack stands with specific id numbers (can’t remember numbers) were recalled due to defects/collapsing or something. I just googled it, it’s on the web.
I usually purchase Harbor Freight tools for one time use... probably not a good idea with jack stands. :thumbsup:
 
Back
Top