More Interior Work
I have been getting quite a bit done on the Overlander over the last two months, but just no time to post about it...so here is a quick update...
Been focusing on the interior cleaning up all the little bits like the floor shifter and putting the new front seats in, and restoring the seat belts. I also installed a factory console, which I had to trim to allow the floor mounted ebrake to work. It also sits further back then stock so that it doesnt interfere with the shifter when its in 1st gear.
Finally, I also added a set of OEM fog lights, but havent wired them yet.
Here are a few pics
Seat Belts before:
IMG_3526 by
jerseyjeeps, on Flickr
Seat belts apart and sprayed the plastic housings with trim paint, followed by new decals. I found these on a forum from a guy in Mexico by searching for "TRW seatbelts" on google. The name TRW is stamped on them and "Made to Australian Spec ...." Turns out they are the same stickers that TRW belts in some early porsches use, and he reproduces them for those cars.
DSC06051 by
jerseyjeeps, on Flickr
DSC06059 by
jerseyjeeps, on Flickr
Console fitment near ebrake - its close, but it fits well. The trimming is just on the side to allow the mechanism to move when pulled, not the front or the back.
IMG_3317 by
jerseyjeeps, on Flickr
DSC06152 by
jerseyjeeps, on Flickr
IMG_3311 by
jerseyjeeps, on Flickr
IMG_3299 by
jerseyjeeps, on Flickr
And the Marchals...I am normally not a fan of these but on the Overlander with the protruding turn signals I think they do a good job taking the eye away from them
Also, those turn signal lenses I replaced too, if you look back at the old pics you can see they were barely orange anymore.
IMG_3324 by
jerseyjeeps, on Flickr
Next up is trying out some oem wheel choices, likely oem chromes, and installing the stealth power window kit and door repair on the LH side door. Oh, and I still need a nice original glove box door in Olympic white....whos got one?
