- City
- W-S
- State
- NC
When you hook up the "safety chains" because you know she ain't gonna make it!
Epic fails
- Thread starter mysunnshine
- Start date
- City
- W-S
- State
- NC
Took this in Florida a few years ago...........It was a straight axle out of a boat trailer!
- City
- W-S
- State
- NC
Shudda flipped the picture over in the repair manual then it would have been correct!
Are those copper break tubes?
- City
- Richmond
- State
- TX
I am assuming cupronickel or nickel-copper.
But I am less concerned about the line type than the fact the rubber part is connecting a fitting on the frame to a fitting on the frame, and the hard lines from the Tee is running to the brake cylinders. All the flex will be in the hard lines! The flex line will have virtually no movement.
- City
- Surf City
- State
- NC
Winner winner … that caught my eye faster than the copper
- City
- W-S
- State
- NC
What, you've never seen "temporary lighting"? I wonder if they're in series or parallel?
- City
- W-S
- State
- NC
there's the absence of wire nuts which leads me to believe at least a YT video was watched
- City
- Surf City
- State
- NC
i love how they run under the hardtop. I saw this personally at a Petco parking lot.
tom keyes
1981 CJ-8
- City
- Louisville
- State
- co
Notice the angle iron setup for the shock mount as well. This person must have worked with the yahoo I let touch my Scrambler this last winter before I had to go and take it back. I have never let anyone touch it but didn't have a garage to work in or the time. I just know it was a poor idea to go with. Several weeks of work and re-wiring the engine. I hope it wont poop out on me from something else the guy did?
