- City
- Madison
- State
- AL
I'm having a problem with my wife's WJ Grand Cherokee and I'm stumped at the moment. Any of y'all have any ideas?
Here's the info:
2001 Jeep Grand Cherokee Limited with a 4.7L
Before Christmas, got an engine code that said:
Error
P0601
Internal Control
Module Memory Check
Sum Error
Ordered and installed a replacement from http://www.allcomputerresources.com/ with a lifetime warranty.
That seemed to fix it until....now.
Last weekend, my wife was driving it on the interstate at around 70 and she said it "lunged" twice so she did the right thing and pulled off and called me. I told her to just try and limp it home and so she proceeded and it died entirely not far down the road and would not re-crank. Starter will turn the engine but no crank (or fire and run). Towed it home where I've begun my own diagnostics to no avail thus far. There is no code thrown on the dash (no check engine light) and I'm getting ~50psi at the fuel rail both with ignition in the "Run" position and while cranking. I replaces the Cam Position Sensor and that did not do it. Have not been able to successfully determine if I have spark or not due to the lack of spark plug wire because of how it's configured with each individual coil right on top of the plugs.
Anybody have any suggestions as to where I should go from here?
Thanks.
Here's the info:
2001 Jeep Grand Cherokee Limited with a 4.7L
Before Christmas, got an engine code that said:
Error
P0601
Internal Control
Module Memory Check
Sum Error
Ordered and installed a replacement from http://www.allcomputerresources.com/ with a lifetime warranty.
That seemed to fix it until....now.
Last weekend, my wife was driving it on the interstate at around 70 and she said it "lunged" twice so she did the right thing and pulled off and called me. I told her to just try and limp it home and so she proceeded and it died entirely not far down the road and would not re-crank. Starter will turn the engine but no crank (or fire and run). Towed it home where I've begun my own diagnostics to no avail thus far. There is no code thrown on the dash (no check engine light) and I'm getting ~50psi at the fuel rail both with ignition in the "Run" position and while cranking. I replaces the Cam Position Sensor and that did not do it. Have not been able to successfully determine if I have spark or not due to the lack of spark plug wire because of how it's configured with each individual coil right on top of the plugs.
Anybody have any suggestions as to where I should go from here?
Thanks.

