• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

HELP! - Anybody know about WJ's? Got a dead one.

CJ8LVR

Legacy Registered User
SOA Member
City
Madison
State
AL
I'm having a problem with my wife's WJ Grand Cherokee and I'm stumped at the moment. Any of y'all have any ideas?

Here's the info:

2001 Jeep Grand Cherokee Limited with a 4.7L

Before Christmas, got an engine code that said:
Error
P0601
Internal Control
Module Memory Check
Sum Error

Ordered and installed a replacement from http://www.allcomputerresources.com/ with a lifetime warranty.

That seemed to fix it until....now.

Last weekend, my wife was driving it on the interstate at around 70 and she said it "lunged" twice so she did the right thing and pulled off and called me. I told her to just try and limp it home and so she proceeded and it died entirely not far down the road and would not re-crank. Starter will turn the engine but no crank (or fire and run). Towed it home where I've begun my own diagnostics to no avail thus far. There is no code thrown on the dash (no check engine light) and I'm getting ~50psi at the fuel rail both with ignition in the "Run" position and while cranking. I replaces the Cam Position Sensor and that did not do it. Have not been able to successfully determine if I have spark or not due to the lack of spark plug wire because of how it's configured with each individual coil right on top of the plugs.

Anybody have any suggestions as to where I should go from here?
Thanks.
 
Jake, you need to pull the codes. Just because there is no CEL, doesn't mean the computer won't have codes stored.
 
I haven't been able to borrow a code reader yet but since then, I've found a damaged wire (likely due to heat from the exhaust manifold) near the connector for the Crank Position Sensor. This may be my culprit. Working on that tonight and going ahead and throwing in a new CPS since it's a royal pain to get to above the starter on the side of the block. We'll see if that does it. If not, will pull codes next. Jennifer is getting antsy to have her Jeep back.
 
x2 on the CPS. The one I used to have did the same thing.
 
Well dang, CPS not the fix. Replaced it along with a repair to a damaged wire right next to that harness connector and still nothing. Just turns the engine with no crank. I used a friends code reader and it doesn't see any codes. I'm starting to question that pcm computer now. I'm stumped right now. Going to try to see if I have spark with an online spark plug test light in the morning if I can get it to work with the coil on the plug setup.
 
fuses

Jake check all the fuses i had one blown on my truck and it would do the same thing, it surged twice then died and would crank but no start, know mine is a diesel but it's worth a check. Can you check to see if your getting voltage to the coils?
 
My son's 2000 WJ fried the computer somehow several years ago. I had it towed it to an independant mechanic, he said only the dealer could replace and program it. It turned out to be a very expensive repair.
 
Sorry guys I haven't updated. Eric is right, disconnected harness connector. Found it while removing the computer to mail back. Glad I found it. Check all connectors first! Thanks for yalls input.
 
Back
Top