Well oil is in, batt is charged, full of coolant, and cranks strong. But no start. Chasing things down, the ‘97 XJ ECM, that came with the running engine when I pulled, has 12V and GND where it should. Fuel pump comes on and goes off like it should in Run. For some reason the ECM is not closing ground for the ASD in the PCM during cranking. I’ve got the Hesco CPS harmonic dampener set up. The sensor is open between B and C as stock should be. With the ignition in Run and the sensor connected/disconnected there is 5V at the A and C terminals. B is confirmed ground. I’m going to check the CPS wiring AGAIN, but what else makes the computer happy enough to give me my ground at the ASD? Any thoughts?