- City
- Lynchburg
- State
- VA
Last edited:

I would check what Randy said first, NSS and ignition switchNeutral safety switch could explain the no crank. But if the ign switch is in the “run” position, then jumping the starter should start it up. IGN switch failure or possibly loose on column and not allowing the rod to fully actuate it? Sorta debunked by the lights dropping out in the start position but other than that I don’t know.
Solenoid is new, same as NSS, it DOes start when the solenoid is crossed... I'll look into the ig switchBut if the ign switch is in the “run” position, then jumping the starter [solenoid] should start it up.
Can you post a better picture of the solenoid?OK, still at it. Learning as this issue is not my Forte....
Currently I have no spark between battery and S on solenoid.
New positive battery cable, new solenoid. Tried another solenoid too.
In the bottom pic, what is the connector touching the brown Tran dipstic View attachment 108298View attachment 108299

If you're referring to the one on the bottom then yeah it has that.If its a factory auto the starter solenoid is different, it has a third post for a black wire which gives the ground to the starter solenoid when in park and neutral
I cannot see this on your photo?.
View attachment 108318

3b Connect a temporary jumper (wire or black lead of jumper cable) from battery negative post to #5 NSS post on solenoid.