Only a few minutes, so drilled out the area where the the tailgate would normally go into so it won't rattle around...will weld/body work those before the panel goes on.
I had to put it all back together to figure out where the roll bars are now and figure out how to make a plate to support them.
I can't do the rollbar extensions until I get those rollbars where they belong... right now side to side they are about 1/2-3/4" off, so I was trying to figure out where it is tweaked.
cb
I really like the idea of the Jeep tailgate piece as the front wall... I probably will end up with a CJ style toolbox that would end up covering it, but it would be cool to have it there none the less. It just doesn't really fit too well right now.
cb