- City
- Biloxi
- State
- MS
Late start but got a good amount of work accomplished today.
Got the old u-joints out:

I also removed the "large spindle shield races" off both stub shafts due to excessive corrosion. If these are in good shape I reuse them.
Cleaned the axles and spindles up, mainly removing rust:

Cleaning rust off the back of spindles. All the important areas are rust free, I mainly just wanted to clean up the back side bore. The large seal will not hit the outer ridge, but just wanted to clean it up.

Stub shafts are in good shape, too:

Not the best picture, one minor nick in one of the axle shaft u-joint cup bores, smoothed it out with a file.

Cleaned the knuckles and splash shield up, too. Both splash shields were in pretty good shape so I will reinstall them.

Installing these metal spindle seal things is a PIA. I could not press or smack them on. So, I treated them like a ring gear on a flywheel. I heated them up with the torch for about 5 minutes then slid them over the stub shafts. Worked like a charm.


Successfully installed both front axle u-joint assemblies without damage or making a trip to the parts store for another u-joint, always proud of myself when I do that!!! Also pressed in the new spindle bearings

Got the old u-joints out:

I also removed the "large spindle shield races" off both stub shafts due to excessive corrosion. If these are in good shape I reuse them.
Cleaned the axles and spindles up, mainly removing rust:

Cleaning rust off the back of spindles. All the important areas are rust free, I mainly just wanted to clean up the back side bore. The large seal will not hit the outer ridge, but just wanted to clean it up.

Stub shafts are in good shape, too:

Not the best picture, one minor nick in one of the axle shaft u-joint cup bores, smoothed it out with a file.

Cleaned the knuckles and splash shield up, too. Both splash shields were in pretty good shape so I will reinstall them.

Installing these metal spindle seal things is a PIA. I could not press or smack them on. So, I treated them like a ring gear on a flywheel. I heated them up with the torch for about 5 minutes then slid them over the stub shafts. Worked like a charm.


Successfully installed both front axle u-joint assemblies without damage or making a trip to the parts store for another u-joint, always proud of myself when I do that!!! Also pressed in the new spindle bearings





















































