Hi Gang,
Well... it turns out that installing a factory cruise control system is as bolt-on and as easy as it seemed it should be. I've completed the install and it works perfectly. Cruising at a set speed, speeding up and slowing down can now all be done using the cruise control switches on the turn signal control switch.
The cruise control is every bit as smooth and stable as the one on my 2008 Toyota. The only thing I noticed is that going up hills takes the system awhile to get back up to speed and going down hills takes the system awhile to slow down. There are adjustments on the regulator for centering, sensitivity, and low speed cut-in, I may play with them a bit to see how I can impact the system.
As far as the installation goes, it was really quite easy:
Day 1:
Install the turn signal / cruise control switch. This entailed removing the steering wheel, horn parts, locking ring, and the turn signal stalk. The only trick to this part of the job was removing the pins from the four wire connector at the end of the cruise control switch. Since I have a tilt wheel, the connector needs to be removed to feed the wires down the column next to the turn signal wires. On a manual column, the connector will fit through the column without removing the pins.
Day 2: (the longest day)
Install the servo on the driver's side fender. The holes on my fender were already there so all I had to do is bolt the servo on. Connect the servo throttle cable to the EXISTING (yes, the factory throttle bracket, at least on my Jeep, is already configured for cruise control) throttle bracket. Gotta love Jeep for this. Bolt on the vacuum reservoir. Drill a 1/2" hole in the firewall straight back from the servo. Remove the six wires from the servo connector so that I can feed the wires through the hole. Feed the wires and the vacuum hose that goes to the clutch cut-off switch through a grommet and through the hole in the firewall. Replace the pins into the connector. Connect one vacuum line from the vacuum reservoir to to a vacuum fitting at the base of the carb and the other vacuum line from the reservoir to the servo.
Remove the old speedometer cable and install the new speedometer cable that has the speed sensor in the middle of it.
Day 3:
Plug everything in on the inside of the cab. The regulator plugs into the connector that came through the firewall from the servo. Find the EXISTING cruise control plug (thanks again Jeep/AMC) behind the dash near the brake switch and plug it in. Plug in the harness from the turn signal control switch. Bolt on the clutch engage switch (note: this switch also has a vacuum disengage feature that connects to the vacuum line that ran through the firewall from the servo). Attach the electronic regulator to the firewall. Plug in the power connector to the cruise control outlet on the fuse box.
The next step was to take it for a test drive... the moment of truth.... usually the moment where I find out I did something wrong... but not this time. I accelerated up to 45mph, turned the cruise control switch to on, and (holding my breath) pushed the set button. I felt the accelerator peddle move ever so slightly away from my foot and the speed settled in at 46mph. I tested the accelerate and decelerate features and they worked perfectly. A smile settled on my face
Here are a few random pictures:
I still need to route some of the wires underneath my dash and permanently mount the electronic regulator (it is on velcro now so I can make the necessary adjustments easily).
All in all... this was quite a satisfying modification.
Joe