What's on your Work Bench?

[rubclt]

A little break from jeep work to throw axes with friends. Now I have to fix a few axes

 

[mhinchliffe]

Hard to believe they’ll let you drink alcohol and throw these things. It’s an underwriter’s nightmare come true.
Look to be a blast tho. I’m thinking darts for real men!

 

[Belizeit]

Always wanted to throw some hatchets. Mine is more like a family heirloom so I would need to find another. Was my dads BSA one. Got my brother to ruff out some new handles a few years ago. Wish I had done a better job with the rivets.

 

[ag4ever]

Brave man, using a new truck as the backstop for target misses.

 

[spankrjs]

 

[Randyzzz]

View attachment 101945

Haven’t seen one of those for ages!

 

[timo439]

Haven’t seen one of those for ages!

I am surprised they didn't put the manual on a USB stick.

 

[ag4ever]

I am surprised they didn't put the manual on a USB stick.

 

[Rosco1974]

My workbench is outside today. Got a $150 Warn rear bumper that needed some work.

 

[Belizeit]

Nice ! I have just like that with swing out tire carrier

 

[mhinchliffe]

Always finding those deals! Nice score and repaint!

 

[timo439]

 

[mhinchliffe]

Batteries?

 

[timo439]

Batteries?

1 of 2 packs to power the conversion.

 

[mhinchliffe]

If you start launching satellites and buy up a poop ton of social media stock at least we can all say we knew you before you made it big!

Cool as heck project!

 

[spankrjs]

Carter YFA

 

[jc_chandler]

Used my new Eastwood 4" metal bender to fab up brackets to mount my electric power steering pump. This little thing handled 3/16 no problem, I think I'm going to get a lot of use out of it.

 

[83CJ-8]

Eastwood 4" metal bender.

I'm going to have to look into that

 

[jc_chandler]

Building an factory-ish replica bumper. Had a sheet of 11ga bent into a channel to mimic the factory step bumper look and then drilled and welded in mounting brackets for a set of @Kim Dawson end caps along with brackets for mounting to the rear crossmember. It's 1" narrower than a factory bumper to give it a tighter looking fit. I thought about doing a spare tire relief area like on the factory bumpers but honestly my fab skills aren't that good and I'm not going to be running a factory swing away spare mount. The bumper will bolt to the rear crossmember through some modified hard rubber bumpers I had laying around. I think I'm going to paint the bumper black and the end caps body color. IMO not too bad for a couple hundred bucks in supplies.

 

[gr8dain]

Not on a work bench yet, but I pulled the transfer case out to replace seals. It has been leaking badly lately. I will probably replace the seal on the trans output as well.