What's on your Work Bench?

[spankrjs]

 

[rubclt]

16 foot baseboard and door window trim for my sons remodel.

 

[rubclt]

Finally put finish on the overland battery box. First time spraying Raptor Liner from a can. I figured out how to use it when I was done.

 

[FLCJ8]

I finally found some spare time to get back on assembling my lift...
(well the control panel)


View attachment 116610

It's alive...
The lift, not the 8.




I did also modify the mount and brackets to relocate the pump/reservoir for more clearance around the lift.

 

[spankrjs]

 

[rubclt]

Skids for the JT back from powder coat and ready for install.

 

[John N]

Progressing along on my engine swap. Ended up pulling off the driver side fender to get the header on that side. Then decided to repair some damage to the inner fender that was there when I bought it long ago. The inner fender was bent up at the rear and had pulled off of the rest of the fender. I straightened it out as best as I could and used panel adhesive to bond it back in place. We’ll see if the adhesive holds tomorrow.

 

[AdamH]

Disassembly of some doors. One down one to go on this beautiful Carolina day! My helper has done nothing but soak in the Sun

 

[Interceptor]

well I have figured out one thing about ordering parts for Jeep. They say they will fit in ads, but you have to make them fit.

Been drilling new holes, now the bumper winch shield is on a work bench being enlarged so it will align with Rocky Ridge bumper bolt holes.

 

[rubclt]

Shop floor is the work bench today as we assemble the Next Venture Motor Sport underbelly skid for a Gladiator.

 

[John N]

Out of my shop and headed to Eli’s shop tomorrow for Sniper installation and initial firing on the engine.

 

[Belizeit]

View attachment 117338
Out of my shop and headed to Eli’s shop tomorrow for Sniper installation and initial firing on the engine.

Original Sniper off the old engine, or a new one ?

 

[timo439]

Pulling the auto transmission out of one of my Eurovans to get it rebuilt or replaced. A bit of a nightmare but it’s out

 

[CHIEFWAHO]

Spring in the pressure washer unloader valve had had enough.

 

[John N]

Original Sniper off the old engine, or a new one ?

My prior engine had a Howell TBI system. This engine is getting a new Sniper system.

 

[spankrjs]

 

[CHIEFWAHO]

 

[CHIEFWAHO]

Don't quite fit on the work bench, but mounting the 43's was a helluva workout!

 

[TexasAg77]

Don't quite fit on the work bench, but mounting the 43's was a helluva workout!
View attachment 117476

Seems like the short drive north to Topeka would have saved a bunch of grief...

 

[mhinchliffe]

How about the oil drain valve on my Simplicity Legacy XL with a Kawasaki FD750D. Not too much room so I had to remove the engine mounting bolts to slightly elevate and trust it to gain access.