- City
- W-S
- State
- NC
Found! Thx to that special someone......Great bunch of guys 'round here!
1983 frame off refresh - finally
- Thread starter mhinchliffe
- Start date
- City
- W-S
- State
- NC
Getting around to it..........
Gotta love the FF rear - 5 minutes for both sides!
Both rings are etched "48"
My removed is pinion is marked "29" and its replacement is "30" - so I figure I'll go -1 on the pinion shims and see what that gets me as far as pattern.
Stay tuned
Gotta love the FF rear - 5 minutes for both sides!
Both rings are etched "48"
My removed is pinion is marked "29" and its replacement is "30" - so I figure I'll go -1 on the pinion shims and see what that gets me as far as pattern.
Stay tuned
- City
- W-S
- State
- NC
Road tested!
Thank you CJ8 brothers!
Thank you CJ8 brothers!
- City
- W-S
- State
- NC
Gonna have to go to Spanks thread and see what he does about these stubborn D20 covers
- City
- Biloxi
- State
- MS
Cork gasket and aviation sealant on both sides of gasket. Slowly tighten all bolts up to torque. I start at top and just go around the whole cover 3-4 times until I reach torque spec. Make sure the inner cover lip, the portion that actually make contact with the cork gasket, is not bent. My green Scrambler's rear cover had a slight ding on this lip, so it always dripped a hair. Hammer, punch, 10 seconds, fixed 
- City
- W-S
- State
- NC
- City
- Biloxi
- State
- MS
I'm just not sure how well they will work with the AMC20's "recessed ridge" deal. They work great on flat flange Dana 30/44's
- City
- W-S
- State
- NC
Getting around to my side steps finally
- City
- W-S
- State
- NC
Had to clean up the old Scat Blast and get to work
- City
- W-S
- State
- NC
And 1 side done!
- City
- W-S
- State
- NC
And almost 3 years to update this thread! Sorry, but I've been driving it and it hasn't really broke in a while. there, I just put the hex on myself!
- City
- W-S
- State
- NC
I know I’ve posted this before but it’s how it works
- City
- W-S
- State
- NC
- City
- W-S
- State
- NC
STOP!
- City
- W-S
- State
- NC
At a snails pace it’s on. Lots happening here at the home place, all good stuff.
- City
- W-S
- State
- NC
She’s showing her age and I think the fabric itself is shrinking. I ran self tappers through the hem and fixed to the aluminum mounting rail. Next is to see about fixing the zippers on the rear window, they’re missing. But at least I can drive it this winter.
- City
- W-S
- State
- NC
That’s the reason I preheat it with the torpedo heater. It definitely makes it easier to get it installed